Skip to content

What is a pool robot cleaning cycle?

Reviewed on November 15, 2026

A cleaning cycle is one full run of the robot. It starts when you switch the robot on or when a timer does. On the models in the sources below, it ends when the set run time is used up.

That's the short version. The details differ by model, and other robots may end a run differently, so check your own manual.

What happens during a run

The order of the steps depends on the maker. One retailer's guide for a Dolphin model has you connect the cord to the power supply and plug the supply in. Then the cleaner goes in the water. Then you press the ON/OFF switch on the power supply.1 Other makers, such as Fluidra, say to power the robot on and connect it before it goes in the water.2 Follow your own manual's order.

Then the robot moves around on its own. A small chip inside runs the drive motors, and Wikipedia says that same chip turns the machine around at a wall or at the surface.3

One cleaning cycle from start to stopRobot is set up as the manual saysPower or start is switched onRobot cleans until timer runs outRobot shuts itself down
On the Dolphin models in the sources, the robot runs until its timer ends, then stops.

How it knows it's done

On the Dolphin models in these sources, the run ends when the set time is up. The sources don't say whether any robot stops by sensing that the pool is clean, so check your manual.

A retailer's guide for one Dolphin model says it shuts down by itself after about 3 hours.1

Other robots let you pick the length. One Dolphin manual says the cycle time setting lets you choose between 1.5 hours, 2 hours and 2.5 hours.4

For how those times get chosen, see how cycle length is set.

Single run or repeating

A cycle is one run. A schedule is a plan for several runs. They're different things, and the two get mixed up a lot.

One cycle A schedule
What it is A single timed run A set of starts on chosen days
Who starts it You, or one timer The robot, at the set times
Ends when The run time is used up Each run ends as the robot's manual says
Suits A quick clean on a day you're home Owners who want it done without being there

Other robots may work differently, so check your manual. Ecovacs says to set a start time and a run time, then put the robot in the pool. It begins at the set time.5

Pages on delay timers and weekly schedules cover each one.

Where the cycle can differ

  • Length. Fixed on some robots, chosen from a short list on others.4
  • Movement. Wikipedia describes the chip turning the robot at a wall or at the surface. Your model's route may differ.3
  • Start. By hand, by a delay, or by a schedule.

The manual for your own robot is the only reliable list of what yours does. Follow it for starting, stopping and taking the robot out of the water.

Before the first run

Read three things in the manual. Find the run time. Find out how the robot stops, whether on its own or by a switch. And find the power supply rules, since a robot should only be started when the manual's setup is followed. The page on safe checks shows examples.

Reference list

  1. How To Operate a Maytronics Dolphin Nautilus Robotic Cleaner, INYOPools.com
  2. How to Schedule a Cleaning Cycle in the App, Fluidra Pool Help Center
  3. Automated pool cleaner, Wikipedia
  4. Dolphin user instructions (app section), Maytronics, copy hosted on ManualsLib
  5. How to Use Schedule Cleaning?, ECOVACS