Skip to content

Weekly schedules on apps and remote controls

Reviewed on November 15, 2026

A weekly schedule is a plan for several runs. You pick days, a start time and often a length. The robot then starts by itself.

App or remote

Both can hold a schedule. They feel quite different in daily use, and a robot may offer only one of them.

App schedule Remote or power supply schedule
Where you set it On your phone On a handheld remote or the unit's buttons
Needs A connected robot and the maker's app The remote or power supply nearby
Handy for Changing days from anywhere Simple setups with no phone link
Watch for The robot must be connected before it goes in the water1 Buttons and lights that differ by model

Don't read too much into this table. Your model may do one, both or neither. A Maytronics page says features in its app vary by model.2

What the makers say

Maytronics says its Weekly Timer feature lets you set an automatic cleaning schedule for the week ahead.2

Fluidra's help page describes a Multi-day mode with a few limits.

  • A maximum of 4 cleaning sessions per week.1
  • Floor cleaning only.1
  • The schedule is valid for one week and must be set again after.1

Ecovacs gives the same order of steps. Set the start time, power and running time, then place the robot in the pool.3

What must be ready before a scheduled startRobot powered and connectedSchedule saved in app or remoteRobot placed in the waterRobot starts at the set time
A schedule only works if the robot is set up first.

The pattern is the same. You set it up, put the robot in the water, and it runs without you.

When the robot isn't ready

A schedule can't start a robot that isn't set up. Sources point to four things that can go wrong, and each one is simple to miss.

  • Not connected. Fluidra says to make sure the robot is powered on and connected before placing it in the water.1 Ecovacs says the robot must be connected to its app.3
  • Schedule ran out. On Fluidra's mode, the schedule is valid for one week only. After that nothing runs until you set it again.1
  • Robot out of the water. The robot has to be in the pool for a scheduled start.3
  • Battery. Ecovacs says you may take the robot out for charging when it isn't working, then put it back for the next task.3

The sources don't say what each robot does when a start is missed. Some may skip the run. Others may not, and a few could try again later in the day, though nothing here says so. Your manual or the maker's support page is where the answer lives.

Before you rely on it

Run the schedule once while you're standing there. Watch that the robot starts and that the pool is clear. Then read the pre-start checklist. It's short. Skipping it is the real risk with automation, because nobody's standing there when the robot starts.

If you're deciding how many runs to book, how often to run a pool robot covers what makers say.

Reference list

  1. How to Schedule a Cleaning Cycle in the App, Fluidra Pool Help Center
  2. MyDolphin Plus App, Maytronics
  3. How to Use Schedule Cleaning?, ECOVACS